A weekly report prepared by the staff of the Ministry of Agriculture, Food and Rural Affairs (OMAFRA). If you require further information, regarding this report, call the Elora Resource Centre at 519-846-0941. Office hours: 8:30 a.m. to 4:30 p.m. For technical information, call the Agricultural Information Contact Centre at 1-877-424-1300 or visit the OMAFRA website: www.ontario.ca/omafra
Some corn harvested in Ontario this year has concentrations of toxins from ear moulds that are elevated to levels that are too high to be used in animal feed.
This could lead to questions about what can be done with this corn, either prior to or after processing. Land application is a possibility.
The following rules apply to corn or corn by-products that has been processed or aggregated so that the resulting material includes corn from more than one farmer. These materials can be land applied as a Category 1 NASM.
These materials can be land applied for their nutrient value, but they do have the potential to be odourous. Land application would be subject to the following limitations:
Application rate
Category 1 NASM can be land applied at a rate of up to 20 wet tonnes per hectare (8.9 tons per acre) without analyzing the material or the soil.
Caution should be exercised at the higher end of this range, as the high protein content of the distillers grains could lead to excess nitrogen applications (NMAN crop removal estimates for corn are 83-42-29 lb of N-P-K for every 100 bu, or 6.3 tonnes at 15.5% mp).
Application rates of greater than 20 wet tonnes per hectare are possible, but both the soil and the material (i.e. distiller’s grains) must be analyzed for nutrients and metals, and the application rate would be limited by the ability of the crop to utilize the nutrients applied.
Land application setbacks
The following minimum application setbacks from wells must be maintained when applying the material:
– 15 metres from a drilled well that is a minimum of 20 metres deep with a watertight casing to at least 6 metres below ground;
– 100 metres from a municipal well; and
– 30 metres from all other wells.
The following minimum application setbacks from surface water must be maintained when applying the material:
– 20 metres from the top of bank; or
– this distance can be reduced to as little as 3 metres if certain conditions are met. Refer to Ontario Regulation 267/03, Section 52(7) for details.
The following minimum application setbacks from neighbours must be maintained when applying the material:
– no application is allowed within 25 metres of a dwelling;
– between 25 and 90 metres from the dwelling, the material must be incorporated within 6 hours;
– No application is allowed within 50 metres of the property line of a residential area (a group of four houses, each lot less than one hectare), or an area of commercial, community or institutional use (for instance a store, a town hall or a school); and
– between 50 and 450 metres from the property line, the material must be incorporated within 6 hours.